Hand stop PTS Enhanced Polymer M-LOK — Tan

The PTS Enhanced Polymer Hand Stop is a low-profile hand stop for airsoft, compatible with any handguard featuring an M-LOK system. At 40×27×19 mm and 11 g, it mounts to the rail without adding noticeable bulk or weight, keeping the replica's lines clean.

Its primary function is to prevent the support hand from sliding forward toward the muzzle: on short replicas or SMGs, where the distances involved are tight, this is a real risk, and the hand stop eliminates it with an immediate physical reference. On the forward face, EP Dot texturing improves grip when using the stop as a bracing point against barriers or cover, providing additional friction compared to smooth polymer.

The reinforced polymer PTS uses here is the same found across the Enhanced Polymer line, chosen to balance light weight with impact resistance. Rounded edges reduce pressure points on the hand during extended holds — a detail that matters over long play sessions. That said, the low-profile design means this accessory is not intended as a true vertical or angled foregrip: it provides control and a consistent reference point, not a pulling surface.

Key points

• Keeps the hand in a safe position relative to the muzzle on short replicas or compact handguards.
• EP Dot texturing on the front face for stable bracing against barriers during covered shooting.
• At 11 g with a low profile, it does not affect the replica's balance or handling.
• Rounded edges reduce hand pressure during extended sessions.
• Direct M-LOK mounting with no additional adapters required.

In the box

• PTS Enhanced Polymer Hand Stop M-LOK