Viper Tactical Modular Shotgun Cartridge Holder

Compact shotgun shell holder for pump-action or semi-automatic shotguns, mountable on any MOLLE/PALS system. At 11x8x3 cm it takes up minimal space on a vest or belt, and is designed for those who need reload shells immediately at hand during hunting or operational use.

The 4 elastic loops retain each shell individually and allow single-motion extraction, with no clips to release or covers to open. This open-top design is the fastest available for both drawing and reloading shells, but offers lower retention than a rigid retainer or a velcro-covered flap: shells are held securely under normal conditions, but a hard impact or an inverted position may cause them to fall out. Those who prioritise speed of access over maximum security in all conditions will find this system suits them well.

The MOLLE/PALS attachment allows it to be positioned on a plate carrier, chest rig, belt or any compatible surface, placing the access point exactly where it is needed.

Key points

• The 4 elastic loops allow immediate shell extraction with no additional steps.
• The compact dimensions (11x8x3 cm) keep bulk on the load-bearing system to a minimum.
• MOLLE/PALS compatibility allows mounting on any vest, belt or back panel already in service.
• The open-top design speeds up shell reloading compared to any covered system, at the cost of reduced retention in extreme conditions.